# A way to display the value of a parameter after recalling a patch **URL:** \ **Category:** Feature Wish List\ **Created:** [18 February 2021 22:17 UTC](https://forum.udo-audio.com/t/a-way-to-display-the-value-of-a-parameter-after-recalling-a-patch/255 "2021-02-18T22:17:51Z")\ **Posts on this page:** 1\ **Showing post:** 12
**Author:** ![four\_corners](https://avatars.discourse-cdn.com/v4/letter/f/96bed5/32.png) [@four\_corners](https://forum.udo-audio.com/u/four_corners)\ **Post date:** [2 March 2021 17:00 UTC](https://forum.udo-audio.com/t/a-way-to-display-the-value-of-a-parameter-after-recalling-a-patch/255/12 "2021-03-02T17:00:51Z")
I sent this suggestion to UDO in October and they thought it sounded like a good idea and made a note of it, who knows if it will be implemented though… _On the DSI/Sequential OB-6 and P6, when you are on a saved patch, and you change a knob, if you rotate it back to the actual parameter setting of that patch, a little red dot shows up on the patch number display to signify you have matched that setting amount of that saved patch._ _Obviously, the Super 6 has no display, but! Since the “Manual” LED is only ever fully lit when you are not tweaking a saved patch (hence Manual), it is essentially free for a similar task. For example, if I had been messing with the filter cutoff, but want to go back to the actual setting of the patch, as I move the cutoff slider, when I arrive at the setting of the saved patch, the Manual LED would flash for a second, or flash twice quickly, or something else of that nature._ --- _[View the full topic](https://forum.udo-audio.com/t/a-way-to-display-the-value-of-a-parameter-after-recalling-a-patch/255)._