# DDS 1 Pulse Width (PW) not working after v1.6 update (DDS 2 works fine)

**URL:** <https://forum.udo-audio.com/t/dds-1-pulse-width-pw-not-working-after-v1-6-update-dds-2-works-fine/3787>\
**Category:** Super 6\
**Tags:** issue\
**Created:** [10 April 2026 14:48 UTC](https://forum.udo-audio.com/t/dds-1-pulse-width-pw-not-working-after-v1-6-update-dds-2-works-fine/3787 "2026-04-10T14:48:19Z")\
**Posts on this page:** 2\
**Page:** 1

<div class="post-metadata">

**Author:** ![Jiminseok](https://avatars.discourse-cdn.com/v4/letter/j/8e7dd6/32.png) [@Jiminseok](https://forum.udo-audio.com/u/Jiminseok)\
**Post date:** [10 April 2026 14:48 UTC](https://forum.udo-audio.com/t/dds-1-pulse-width-pw-not-working-after-v1-6-update-dds-2-works-fine/3787/1 "2026-04-10T14:48:19Z")

</div>

Hi,

I’m having a specific issue with my Super 6 after updating to firmware v1.6.

The **Pulse Width (PW)** modulation on **DDS 1** is completely unresponsive, while it works perfectly on **DDS 2**. Here is what I’ve observed and already tried:

**The Issue:**

- With **DDS 1** selected (Mixer 100% left) and **SUPER** set to **OFF** , moving the **DETUNE/PW** slider does not change the sound at all (even on Square/Pulse waveforms).

- When **SUPER** is turned **ON** , the slider works fine for **Detuning** , which means the physical slider itself is sending data.

- However, when **SUPER** is **OFF** , the PW remains static regardless of the slider position.

**What I have tried so far:**

1. **Firmware Update:** Re-installed v1.6 and performed a factory reset (Holding PATCH 8 on power up).

2. **Waveform Restore:** Restored the “FactoryWaveforms” folder to the WAVES directory as per the manual (using the PATCH button unlock method).

3. **Calibration:** Performed the MIX/TUNE calibration.

4. **Initial Patch:** Tested on a clean initial patch (SHIFT + MANUAL).

5. **DDS Modulator:** Confirmed that moving the LFO 1/ENV 1 sliders in the DDS Modulator section also doesn’t affect DDS 1’s PW, even when the source switch is set correctly.

It seems like the PW signal path for DDS 1 is software-locked or failing to map correctly. Since the slider works for Detune, I suspect it’s not a hardware failure of the fader itself.

Has anyone else encountered this or found a fix?

Thanks for your help!

* * *

---

<div class="post-metadata">

**Author:** ![sunlewis](https://avatars.discourse-cdn.com/v4/letter/s/b9e5f3/32.png) [@sunlewis](https://forum.udo-audio.com/u/sunlewis)\
**Post date:** [11 April 2026 01:07 UTC](https://forum.udo-audio.com/t/dds-1-pulse-width-pw-not-working-after-v1-6-update-dds-2-works-fine/3787/2 "2026-04-11T01:07:38Z")

</div>

DDS1 has a square wave, not a pulse. PWM is only available on DDS2
