# S6 Desktop, V0.30, Patch D2 glitch/blast?

**URL:** <https://forum.udo-audio.com/t/s6-desktop-v0-30-patch-d2-glitch-blast/1082>\
**Category:** Super 6\
**Created:** [9 March 2022 18:36 UTC](https://forum.udo-audio.com/t/s6-desktop-v0-30-patch-d2-glitch-blast/1082 "2022-03-09T18:36:37Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![cl516](https://dub1.discourse-cdn.com/flex017/user_avatar/forum.udo-audio.com/cl516/32/343_2.png) [@cl516](https://forum.udo-audio.com/u/cl516)\
**Post date:** [9 March 2022 18:36 UTC](https://forum.udo-audio.com/t/s6-desktop-v0-30-patch-d2-glitch-blast/1082/1 "2022-03-09T18:36:37Z")

</div>

Just received a new Desktop. Updated firmware to 0.30. Any encounter when going to preset D2 there’s a weird glitch and then next notes you play there’s a huuuge noise blast?

FWIW, I went through every other bank and preset and could not repeat this. So I just saved an init blank patch over D2 and hopefully this won’t show up again.

---

<div class="post-metadata">

**Author:** ![DDS](https://dub1.discourse-cdn.com/flex017/user_avatar/forum.udo-audio.com/dds/32/11_2.png) [@DDS](https://forum.udo-audio.com/u/DDS)\
**Post date:** [10 March 2022 08:37 UTC](https://forum.udo-audio.com/t/s6-desktop-v0-30-patch-d2-glitch-blast/1082/2 "2022-03-10T08:37:00Z")

</div>

With firmware version 0.26 we have boosted the output signal generated by the VCA by +6dB and also improved the signal to noise ratio by the same amount. As a result, some of the patches - particularly those with previously high **ENV LEVEL** settings - might cause clipping. Whenever this is the case, readjusting the **ENV LEVEL** setting in the VCA section will solve the issue. Please note that the **MASTER VOLUME** setting has no effect on the amount of gain staging happening in the VCA section, meaning that clipping artifacts can even occur when the **MASTER VOLUME** is set to low amounts.

In short: If you feel like a patch is causing too much clipping, simply readjust the **ENV LEVEL** setting in the VCA section and save the patch with the new setting.

---

<div class="post-metadata">

**Author:** ![cl516](https://dub1.discourse-cdn.com/flex017/user_avatar/forum.udo-audio.com/cl516/32/343_2.png) [@cl516](https://forum.udo-audio.com/u/cl516)\
**Post date:** [10 March 2022 12:16 UTC](https://forum.udo-audio.com/t/s6-desktop-v0-30-patch-d2-glitch-blast/1082/3 "2022-03-10T12:16:12Z")

</div>

Thanks for the info! As a new user, I was slowly getting acquainted with the Super 6 yesterday.

Happy to say that if I respect the clipping levels, all modulations are super duper and glitch-free. All the audio-rate stuff is wonderful!