Hey, I have firmware 1.26 and the pulse width of the pule wave doesn’t seem to change when set to manual and moving the slider.
- Set DDS 2 to pulse wave (far right)
- Set switch to manual
- move PW slider
- No audible result
It works when set to Env 1 or LFO 1. Is anyone else experiencing this? I tried searching the forum and didn’t find any posts on this.
Do you mean moving the PWM slider (with “manual”, “LFO1” and “ENV1” as switch positions? Or do you mean when moving the PW (and Detune) slider to the left of that?
Manual pulse width control is only done with the PW slider, not the the PWM slider. This confused me at first. When dealing with the pulse wave, the “manual” setting on the PWM slider is more accurately “off” or “no modulation”.
(It’s made more confusing that that does however control the manual wave morphing when set to “manual”. It’s even more confusing that the manual amount applied to wave morphing remains in force when flicking the switch to one of the other two positions. This leads to situations where you set the manual amount, flick to LFO or envelope, set a depth with the slider, then if you move back to “manual”, the wave morphing setting jumps to current position of the PWM slider. This really caught me out until I worked out what was going on.)
3 Likes
Ah, thanks. That’s exactly what threw me off.
1 Like