Good evening everyone, I wanted to share my experiences with the Super Gemini and ask if you're experiencing the same problems I've encountered, which I've summarized in several points:
1) Is there a way to set aftertouch to mono?
2) When I set the init patch, LFO2 is monophonic and free-running, and when I change its waveform, it becomes polyphonic and resets with each key press (except with the sine waveform, where it remains polyphonic but free-running). If you don't change the waveform and set the switch to "LFO-on," it remains monophonic.
3) The sample and glide waveform (the last waveform of LFO2) doesn't work. The manual (on page 86) says that "when the modulation sources represented by buttons 1-8 are modulating destinations outside the modulation matrix, their respective LEDs also flash." What does this mean?
4) Why does dds2 reset when used as an osc and is free running when used as an lfo?
5) DDS1, if set to 1/2 (Super setting in the DDS Modulator section), says the 7 waveforms of the 7 super oscillators reset. If they reset, why don't they produce a binaural result, like DDS2 does, which resets itself? 6) I had to turn it off and on again because the "MOD ASSIGN" button didn't work.
7) Aftertouch and Env1, which modulate the LR PHASE, sometimes work, sometimes not (velocity is fine).
8) The LFO2 Trig, if you set the switch to "LFO 2 ON," should modulate both DDS and VCF, like Aftertouch, but instead it only modulates the VCF. Does this happen to you too?
9) How do I set the step length for the sequence? Do I have to set all 64 steps?
Thanks and regards everyone.
Can you reformat your post? Way too hard to read.
1 Like
Thanks in advance, I posted it like this because the normal formatting didn’t let me upload it, regards