MOD ASSIGN LPF - not possible?

UDO Audio Gear Super Gemini
1

Hi All,

is there a way to target the LPF with expression pedal? or some other additional mod sources?

now im thinking about it, is it because that would mess with the other ‘hard wired’ sources, like ENV1 / 1 & LFO 2?

best
Pete

1 Like
2

Totally possible via the mod matrix. There’s a dedicated expression source button.

1 Like
3

As @Quatschmacher indicates, use the Ped/CV button in a direct modulation i.e.

  1. Click Mod Assign
  2. Hold down the Ped/CV button
  3. Whilst holding down Ped/CV button, toggle the VCF: Freq slider
  4. Use Mod Amount dial to set the depth
1 Like
4

ahhh the VCF i hadn’t thought of that - i was trying the LPF.

thanks both, very kind

pete

1 Like
5

Heh, my apologies Pete - I mistakenly thought I was on a Super 6 topic!! But the principle should be the same using the VCF: LPF slider on the Super Gemini!

6

Hi ekeu - ok i must be doing something wrong - i will try again -

I did think the progress was the same as the hard wired panel destinations, but im not getting the MOD amount show up (or any effect if i chose LPF -

but its good to know if should be possible - ill have another go later today - i must be missing a step.

best
Pete

7

In direct assignment, when you hold down the Mod Assign: Source button and toggle the LPF slider, you should see a cascade of lights move through the modulation section buttons from the right to the left, stopping at the light on the source button you’re holding. This indicates that the source and the destination slider have been paired. You can then adjust the Mod Amount dial.